admin

Local Spa Repairs Update A customer reached out because her spa hadn’t been used for several months and had stopped working. Upon arrival, I quickly noticed a humming noise coming from the pump. My initial thought was that a faulty capacitor might be to blame, but a closer look revealed a much bigger issue. There […]

Local Spa Repairs Update A customer’s spa was tripping power every time the heater turned on. After inspecting the system, I found that moisture buildup had caused corrosion in both the heater and parts of the controller. Unfortunately, the only solution was to replace the entire controller, including the heater. Since the existing system was

Local Spa Repairs Update This time, I was called to fix a leak around the skimmer box—a job that had already been attempted by someone else, but unfortunately, the previous repair didn’t hold up for long. The tricky part of resealing a skimmer box is all in the preparation. Removing every bit of old silicone

Local Spa Repairs Update A customer recently reached out after leaving their spa unused for half a year, only to find that the pump had stopped working. Initially, I suspected a faulty capacitor, but after inspecting the pump, it was clear that the drive shaft was completely seized. Testing the water revealed the root cause—an

Local Spa Repairs Update A customer’s Hotspring spa had suddenly lost all functions, leaving it completely unusable. After running diagnostic tests and checking the controller, I found the issue—a sub-board had failed and was no longer providing any power output. The only solution was to replace the faulty sub-board. Once the new part arrived, swapping

Local Spa Repairs Update This time, I was called out to inspect an old SP1000 system that had stopped working and was constantly tripping the power. The issue was quickly identified—a leaking heater at its terminals. Since the spa hadn’t been used in a long time, parts of the controller were also internally corroded. To

Local Spa Repairs Update This time, we received an inquiry from a customer whose spa wasn’t heating and displayed an Error 6. The customer mentioned that the heater had been replaced a year ago due to tripping the breaker. Upon inspection, I found the issue: the connection cables to the heater were completely burned. This

Local Spa Repairs Update This time, I was sent to fit a new spa cover and install a cover cradle for a customer. After carefully unwrapping and fitting the new cover, I unpacked the cover cradle and ensured all parts were complete. The installation began with mounting the tilting frame at the back of the

Local Spa Repairs Update This job was a warranty service call to replace a faulty UV unit on a customer’s spa. The unit was shorting out the power every time it was turned on. Power tripping is a common problem when troubleshooting spas with UV systems. Fortunately, in this case, the UV unit was easily

Local Spa Repairs Update A customer recently contacted us about a suspected leak in their spa. Upon arrival, I began inspecting the most common leak points, such as the pumps and barrel unions, but they all appeared fine. I then removed the side panels to search for water marks or pooling. In one of the